MRV Communications LX-4000 Series - Manual (Page 38)

Alternative Port Capabilities
38
MRV Communications, Inc. www.mrv.com 451-0308
2. Connect the other end to any port you have configured as a sensor port.
Figure 16 - Connecting the Temperature/Humidity Sensor
You must change the port’s “access” to “sensor” before performing any monitoring. Use the
following command, in the Async Port Configure Mode, to configure asynchronous port 4 as a
Sensor Port:
Async 4-4:0>>access sensor
Once the sensor is enabled, you can check the temperature with the following command:
InReach:0>> show port async 4 status
3. You can also monitor the temperature/humidity remotely through the LX CLI. Refer to the LX-
Series Commands Reference Guide for a detailed explanation of the commands used to configure
and view your temperature/humidity sensor through the CLI interface.
5250 Power Management
The 5250 Power Control Series family of products provides easy, practical, and secure solutions for
power distribution, power management and load-measurement for data centers and remote sites.
5250 Power Control Series products are available in a variety of models for 100-120VAC up to 30A,
and for 230VAC up to 16A (Continental Europe). A 5250 Series offers individual remote control over
the power on/off status to a maximum of 32 devices.
See the Technical Specifications Appendix for more information about available 5250 Power Control
Series models.
The following section explains how to connect and install the 5250.
100-240VAC 1.0A 50/60Hz
9 10 11 12 13 14 15 16
10/100 ETHNT DIAG
100
1 2 3 4 5 6 7 8 RCV LINK
TELCO
LINE
15
33 34
RJ45 Double-Ended
Straight-Through Cable