Magma PCIe Expansion System EB2R - Manual (Page 24)

M A G M A
16
If your rack has holes too large for the
screws, you can use the Bar Nut to
secure your mounting by inserting the
Panhead screw through the rack hole
and screwing it into the Bar Nut on the
reverse side of the rack post, as shown:
NOTE
Notice that the holes on the Bar Nut are spaced unevenly to
accommodate different racks.
The EB2 chassis requires two
extender brackets (supplied with
the rack-mounting kit) be installed
on one side of the chassis in order
for the chassis to fit widthwise in a
standard rack.
The extender brackets should be
attached in-between the Bar Nut
and the Panhead screws as
shown:
Extender
bracket
Attach Slide Rail to Rack
Attach the other side of the rack with “fingers” pointing “out” and the end
bracket to the rear. Secure each Slide Mount with 4 screws as shown
below.
Secure the slide rail to the
rack with 2 screws to both
front and rear posts. After
you have secured the slide
rail fingers to the rack posts,
tighten the 2 screws used to
attach the slide rail to the end
bracket.