MGE UPS Systems 2200C - Manual (Page 17)

34007532EN/AA - Page 17
3. Operation
3.4 Personalisation (optional)
Function
Personalisable function
Automatic start
Cold start (battery power)
Forced shutdown
Sleep mode
UPS ON / OFF via software
Default setting
Enabled
Enabled
Enabled
Disabled
Enabled
Personalisation parameters can be set and modified using the UPS Driver software installed on a computer that is
connected to the UPS (see section 2.4 Connection to the RS232 communications port).
Check that the RS232 30 cable is properly connected.
UPS Driver installation:
1 - Insert the Solution-Pac CD-ROM containing the UPS Driver software in the computer drive.
2 - Open the Windows file manager or explorer and select the CD drive.
3 - Run "\Emb\Config\UPSDRVxx.exe", where xx is the software version.
It is also possible to download the UPS Driver software from the www.mgeups.com site.
Once the UPS Driver software has been installed, the parameters listed below can be modified.
"Battery" tab
Personalisable function
Automatic "Battery test" intervals
"Low-battery warning" threshold
Protection against deep discharges
Default setting
Every weeks
20% remaining battery backup time
Enabled
Options
Once a day
Once a month
No test
From 0% to 100% of the remaining
battery backup time
Disabled
Options
Disabled
Disabled
Disabled
Enabled
Disabled
"ON / OFF conditions" tab