Musical Fidelity M6 - Manual (Page 10)

Issue 1 July 2009 Page 10 of 18
NO DISC
cd
CLOSE
cd
PAUSE 1 0:03
cd
STOP 7 41:56
cd
PLAY 1 0:01
cd
LOADING AND PLAYING COMPACT DISCS
To use the CD, press the CD button on the front panel. Alternatively, use the CD button on the remote control.
To load a disc, press OPEN/CLOSE button to gain access to the tray. Display will show “OPEN”
When the tray is fully extended, gently place the disc, with the label facing upwards, centrally into the
indentation and press the OPEN/CLOSE or PLAY button so the displays show “CLOSE”.
The unit will scan the contents of the disc. After a short delay, the display windows then show the total number
of tracks available on the CD, and total playing time. In the following example there are 7 tracks, lasting a total
of 41 minutes 56 seconds
DISC PLAY
If PLAY/PAUSE is pressed, the unit will begin playing from track 1, confirmed by the word PLAY appearing on
the left of the display, with 1 in the centre and elapsed time on the right.
When all tracks on the CD have been played, the display shows STOP and total number of tracks on the disc.
PAUSE
Pressing the PLAY/PAUSE button when disc is playing will hold up playback. PAUSE appears in the display
windows instead of PLAY. The disc will continue spinning, but the track does not advance and the CD's output
is muted.
Pressing PLAY/PAUSE again resumes playback from the same place.
PAUSE (Remote control)
On the remote control, PLAY and PAUSE buttons have separate functions at each end of the same button.
Pressing PLAY will only control disc play, and Pressing PAUSE will not resume play. Note that if the disc is
already playing, pressing the PLAY button reverts to the beginning of the current track.
OPEN
cd
OPERATION