Magellan eXplorist 500 - Manual (Page 45)

Editing a User-Created POI
POIs that you have saved can be edited to change the icon, visibility, name, elevation, and
message. You can also change the location, but keep in mind that this effectively is creating
a new POI in a new location. If the POI you are editing is used in a route, the changes made
to the POI will not be reflected in the route.
1. Press MENU.
2. Use the Arrow joystick to highlight
Pts of Interest.
3. Press ENTER.
4. Use the Arrow joystick up/down to highlight
My Pts of Interest.
5. Use the Arrow joystick left/right to select
Nearest or Alphabetical.
6. Press ENTER.
7. Locate the file where the POI has been saved and press ENTER. (The eXplorist will
automatically open the default file.)
8. Highlight the POI and press ENTER.
9. Use the Arrow joystick to highlight
Edit POI.
10. Press ENTER.
11. Use the Arrow joystick to highlight the field you want to
change.
12. Press ENTER.
13a. If the Icon field is selected: Use the Arrow joystick to select
the icon desired and press ENTER. To aid in your selection,
the type of icon selected is displayed in the information
block at the top of the keypad.
13b. If the Name field is selected: Use the Arrow joystick to
select the character desired and press ENTER. If you make
a mistake, highlight
Back and press ENTER. To access the
lower-case characters, highlight
Shift and press ENTER. To
clear everything and start over, highlight CLEAR and press
ENTER. When you are satisfied with the name, highlight
OK
and press ENTER.
Note: User-entered POI names can be up to 20 characters long (including spaces).
13c. If the Message field is selected: Use the keypad displayed, just as was described
in 13b, to enter a message for this POI.
13d. If the Vis (Visibility) field is selected: Press ENTER. Select
On or Off and Press
ENTER.
14. When the Icon, Name and Message fields are ready, use the Arrow joystick to
highlight
Save.
15. Press ENTER.
Points of Interest 38
Editing an existing POI
with the Vis field
highlighted