CatEye MSC 3Dx - Manual (Page 3)

-3-
Magnet & Sensor
!
Use a coin to attach the wheel magnet q temporarily
to the right side spoke of front wheel.
Caution: Attach the sensor and the magnet within
10cm from the hub axle.
@
Attach the speed sensor 2 temporarily to the right
front fork. Adjust the sensor 2 and the magnet q
referring to the conditions A and B . After adjusting,
tighten the screw
0 and the magnet q .
$
Attach the cadence magnet w to the crank. Adjust the
position of the sensor and the magnet referring to the
conditions A and B . After adjusting, fix the cadence
magnet w with the adhesive tape and the nylon tie 6 .
Bracket
Attach the bracket rubber pad with holder 9 to the bracket
1 and mount it to the handle bar.
Reference: If it does not fit well, use the rubber pad 8 .
Wire
%
Secure the wire along the frame using the nylon ties 6
and wind it round the brake cable up to the handlebar.
Caution: Allow enough wire clearance in the area marked
with
.
Crank
Chain stay
#
Attach the cadence sensor 3 temporarily to the left
chain stay.
Reference:
If the clearance between
spoke and front fork is wider
than 5mm, mount the sensor
band
3 and 4 in an opposite
way as shown.
Front fork Spoke