Meyer Sound M1D User Manual

Page 2

Advertising
background image

ii

DECLARATION OF CONFORMITY ACCORDING TO ISO/IEC GUIDE 22 AND EN 45014

Manufacturer's Name:
Meyer Sound Laboratories Inc.

Manufacturer's Address:
2832 San Pablo Avenue
Berkeley, CA 94702-2204, USA

Declares that the products
Product Name: M1D and M1D-Sub Loudspeakers
Product Options: All

Safety: IEC 60065:1998

EN 60065:1998

UL 6500/09.99

CAN/CSA E60065-00

EMC:

EN 55103-1: 1997 emission(1)

EN 55103-2: 1997 immunity(2)

This device complies with the requirements of the
Low Voltage Directive 73 / 23 / EEC and the
EMC Directive 89 / 336 / EEC.

This device also complies with EN 55103-1 & -2. Operation is
subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including

interference that may cause undesired operation.

Note: Installation restrictions may be applied by supply authorities
in relation to harmonics and voltage fluctuations (flicker).

Supplementary Information

The product herewith complies with the requirements of the Low
Voltage Directive 73/23/EEC and the EMC Directive 89/336/EEC.

Office of Quality Manager

Berkeley, California USA

October 28, 2003

European Contact: Your local Meyer Sound dealer or Meyer Sound
Germany, GmbH. Carl Zeiss Strasse 13, 56751 Polch, Germany.
Telephone: 49.2654.9600.58 Fax: 49.2654.9600.59

Environmental specifications for Meyer Sound Electronics products

Operating Temperature

0˚ C to + 45˚ C

Non operating Temperature <-40˚ C or > +75˚ C
Humidity

to 95% at 35˚ C

Operating Altitude

to 4600 m (15,000 ft)

Non operating Altitude

to 6300 m (25,000 ft)

Shock

30 g 11 msec half-sine on

each of 6 sides

Vibration

10 Hz to 55 Hz (0.010 m peak-

to-peak excursion)

COPYRIGHT

© 2003 Meyer Sound. All rights reserved.
M1D/M1D-Sub Operating Instructions

The contents of this manual are furnished for informational purposes only, are subject to change without notice, and should not be construed as a
commitment by Meyer Sound Laboratories Inc. Meyer Sound assumes no responsibility or liability for any errors or inaccuracies that may appear
in this manual. Except as permitted by applicable copyright law, no part of this publication may be reproduced, stored in a retrieval system, or
transmitted, in any form or by any means, electronic, mechanical, recording or otherwise, without prior written permission from Meyer Sound.

Intelligent AC, M Series, M1D and RMS are trademarks of Meyer Sound. Meyer Sound, Meyer Sound MAPP Online, SIM and QuickFly are
registered trademarks of Meyer Sound Laboratories Inc. (Reg. U.S. Pat. & Tm. Off.). All third-party trademarks mentioned herein are the property
of their respective trademark holders.

Printed in the U.S.A.

Part Number: 05.115.200.01, Rev A

European Office:

Meyer Sound Lab. GmbH

Carl Zeiss Strasse 13

56751 Polch, Germany

Made by Meyer Sound Laboratories

Berkeley, California USA

���

� ������

��

��

��

��

� �

�������

Advertising