Midway SPORTSTATION 16-40094-101 - Manual (Page 6)

1-4
INSTALLATION & INSPECTION
INSTALL THE CONTROL PANEL
WARNING: The cabinet is top heavy. Use the two handles when moving the cabinet.
1. Remove all items from the shipping containers and set them aside. Inspect the exterior of the cabinet,
and control panel for damage. Pay special attention to cabinet edges, seams, and corners.
2. Remove and save the screws at the top and sides of the rear door. Unlock the rear door, then lift it off
the cabinet. Set the rear door aside. Inspect the cabinet interior for signs of damage. Check all major
assemblies to assure that they mount securely. Check the joysticks for signs of damage.
3. The coin door keys are on a key hook inside the cabinet. Unlock and open the coin door. Cash box
door and rear door keys are on a key hook attached to the rear of the coin door. Unlock and open the
cash box door. Remove the spare parts stored in the cash box.
4. Find the leg levelers and nuts in the spare parts bag. Install one nut onto each leg leveler. Hand-turn
the nut against the base of the leg leveler. Install one leveler with its nut into the threaded hole in
each corner of the cabinet. Turn the levelers all the way into the holes, but don’t tighten the levelers.
5. Unpack the player control panel. Place the player panel on the cabinet above the coin door. Open the
player panel. Align panel-mounting holes with holes in the cabinet. Install bolts with washers (two in
back; two on the bottom). Connect wiring harnesses to P1, P2, and P8 on the I-40 Joystick Interface
Board. Close the player panel. Reach up through the open coin door and lock both latches.