MITSUBISHI ELECTRIC XD80U - Manual (Page 20)

E-19
Power Cable Connections and Switching the Power On/Off
There is an order in which the power cable is connected and the power is switched on/off.
AUDIO
RGB
S-VIDEO
VIDEO
ST ATUS
STA ND BY SO UR CE
AUT O
MENU
DUA L CO LOR MOD E
Firmly plug in all
the way.
To wall outlet
Operating
3
Switch on the projector power
Press the STANDBY button.
The first time the power is switched on after purchase, [Menu
Language Select] will be displayed. See Page E-20 for informa-
tion about language selection.
• When the power is turned on, the STANDBY indicator starts blink-
ing green, then stops blinking after about 60 seconds. If the STATUS
indicator lights green at this time, the lamp mode is set to “Low”.
See E-26 and 48 for instructions on selecting.
• If the power does not come on, see “When the STATUS Indicator is
Lit or Blinking” on Page E-54.
RGB
STANDBY
VIDEO CANCEL QUICK
MENU
ENTER
Q
2
ቢ Turn the lens cover clockwise.
ባ When the lens cover stops with a click, the
projector is ready for projection.
1
Connect the AC IN connector of the projector and the power outlet using the supplied power cable.
The STANDBY indicator will light in amber, and the unit will enter the standby mode.
1
ST ATUS
STANDBY
SO UR
MENU
DUAL COLOR
MODE
2
ST AT US
STA ND BY
SO UR
ME NU
DUAL COLOR
MODE
STATUS STANDBY
Lit amber
STATUS STANDBY STATUS STANDBY STATUS STANDBY
This indicator is also lit green in Low-mode.
Blinking green
(Approximately 60
seconds)
Lit green
Power is on
Lit amber
Note:
• When the power plug will be unplugged from the power outlet, please place the projector near the power outlet so that it may be reached
easily.
• Press the STANDBY button after the STANDBY indicator is lit in amber.
• The included power cable is exclusively for use with the XD80U. Never use it with other products.
• Use the appropriate cord for your country.
• The provided power cord for the U.S. is rated at 120 V. Never connect this cord to any outlet or power supply using other voltages or
frequencies than rated. If you want to use a power supply using other voltage than rated, prepare an appropriate power cord separately.
4
Switch on the power of the connected equipment
If the “Password” input window is displayed: See E-31.
A password is set for this projector.
The projector cannot be used unless the correct password is input.
To turn off the power: See E-21.
The projector is now capable of regular projection.
Note:
The image can be muted quickly by closing the lens cover while the image is being projected.
STATUS STANDBY
(button on main unit)