MITSUBISHI ELECTRIC XD80U - Manual (Page 22)

E-21
Power Cable Connections and Switching the Power On/Off
Finishing
1
Switch off the power of the connected equip-
ment
2
Switch off the power of the projector
Press the STANDBY button.
The [Power Off] display appears.
When the level gauge reaches maximum, the projection screen
will go off (in about 5 seconds) and the projector will enter the
power-off operation.
Note:
* The operation can be cancelled by pressing a button other than the
STANDBY button.
* One more press of the STANDBY button will switch off the power.
The STANDBY indicator changes to blinking amber and lights a
steady amber after about 90 seconds (when the unit enters the
standby mode).
Power Off
OK ?
RGB
STANDBY
VIDEO
FREEZE MUTE LAMP MODE AUTO
ASPECT
CANCEL QUICK
MENU
ENTER
Q
1 2 3 4
Blinking amber
(Approximately 90
seconds)
Lit amber
Standby mode
STATUS STANDBY STATUS STANDBY STATUS STANDBY
Lit green
3
Unplug the power cable
Check that the STANDBY indicator is lit in amber and then
unplug the power cable.
The STANDBY indicator will go off when the power cable is un-
plugged.
4
ቢ Turn the lens cover counterclockwise until it stops.
ባ The lens cover will stop with a click.
1
ST ATUS
STANDBY
SO UR
MENU
DUAL COLOR
MODE
2
ST ATUS
STANDBY
SO UR
MENU
DUAL COLOR
MODE
Instant Shut Down
When the power cord is unplugged directly after the power is turned off, the internal power supply is used to keep the cooling
fan turning and cool the lamp, so the projector can be moved immediately.
• It may be more difficult to turn the lamp back on if it has been cooled with the power cord unplugged.
• Do not place the projector in a bag, etc., while the cooling fan is turning.
STATUS STANDBY
(button on main unit)