Marcum Technologies Underwater Viewing System VS825 - Manual (Page 5)

Nature Vision, Inc. www.marcumtech.com
- 5 -
Sharing your video is easy. The video output jack located on the rear of the monitor
allows for adding an external monitor such as a bigger screen TV or a video recording
device. The camera and power cables have been designed with 90° terminal
connections to prevent cable wear. Along with the 90° connections, each cable
connector is keyed differently to prevent plugging the cable into the wrong port. The
rear cable access panel provides cable strain relief and is screwed to the back of the
monitor. The panel securely holds the cables in place and prevents unnecessary wear.
The 75 feet of reinforced camera cable is flexible for ease of handling yet offers high
tensile strength.
The Manta camera incorporates internal ballast weights within the camera housing.
The amount of weight is ideal for trolling at low speeds or keeping the camera tracking
smooth in current. For added open water stability or to use as a down view camera,
the fin (included) snaps into the rear of the Manta camera housing with ease.
Following MarCum’s standards, the VS825c is protected with a stylish reinforced
padded soft pack case. Under the soft pack is a molded ABS hard case with a built in
battery tray and a Velcro strap to securely hold the battery in place. Next to the battery
is a storage compartment for the camera and camera cable. The monitor folds down
flat and the padded case encompasses the entire system protecting it during
transportation. On the left side of the case is a carrying handle for ease of transport.
The sealed 7.2 amp rechargeable lead-acid battery can provide up to 8 hours of
continuous use during ideal conditions. Battery run time will vary depending on the
condition of the battery, use of underwater LED lighting, level of screen backlight
(brightness) and LCD heater system. The 1 amp, two-stage charger will quickly charge
the battery back to full capacity. Once charged, a small green LED light will be
illuminated to indicate the charger has switched to a trickle charge mode.
The VS825c offers a full one year warranty backed by MarCum’s first-rate customer
service!
Getting Started
The VS825c has been set-up and tested at the factory before being placed into its
retail packaging.
Remove the VS825c from the packaging and place on a level surface with the
MarCum Technologies logo facing towards you and right side up. Open the top cover
of the soft pack by lifting up on the Velcro closers on each side and front of the soft
pack. Once opened, loosen the knobs on the either side of the gimbal bracket (at the