McIntosh MDLP1 - Manual (Page 29)

29
How to Operate the MDLP1, con’t
Normal, Zoom, V-stretch and Through) set to
ON a 12VDC output will appear at the Trigger
2 Output Jack; when set to OFF, 0V appears at
Trigger 2 Output Jack.
Remote Control - Selection includes the two built in sen-
sors along with any external sensor(s)
connected via the external IR Input Jack
or just external sensor(s). Refer to page
5, General Information Note 6.
Wireless: Selects external sensor(s)
only.
Wired: Selects the two internal sensors
and any external sensor(s) connected to
the MDLP1.
Note: When making a change to the cur-
rent menu setting, the ENTER Push-
button on the MDLP1 Control Panel
must be used to effect the desired
change.
Reset Lamp Life - The projection lamp used in the MDLP1
has a maximun life expectancy of 2,000
hours.
If at any time you would like to know
how many hours of use are left for the
lamp, press the INFO Push-button on
the Remote Control and the On-Screen
Display will appear indicating the
number of hours remaining. Refer to
figure 34. When there is aproximately
100 hours of lamp life remaining, an
On-Screen Warning Message will ap-
pear briefly. Refer to figure 35. If you
have chosen not to replace
the lamp at this time, a
second warning message
will appear with approxi-
mately 5 hours remaining.
Refer to figure 36. Finally,
the last warning message
will appear On-Screen,
the MDLP1 Projector will
shut Off and the Control
Panel WARNING/LAMP
LED will illuminate red.
Refer to figure 37.
After your McIntosh
Dealer has replaced the
Projector Lamp, check to
make sure the Lamp Life
has been reset by pressing
the INFO Push-button on
the Remote Control. The
On-Screen Display should
indicate 2,000 hours. If it
was not reset please do it
at this time by selecting the Reset Lamp
Life from the On-Screen Menu and then
select YES and press the ENTER Push-
button. Refer to figure 38.
Reset All - If it becomes necessary to reset all the menu
settings back to factory defaults (except for
the Lamp Life Setting),
select the Reset All from
the On-Screen Menu and
then select YES and press
the ENTER Push-button.
Refer to figure 39.
Reset of Microprocessors
In the unlikely event the controls of the MDLP1 stop func-
tioning, the microprocessors can be reset by disconnecting
the AC Power Cord from the MDLP1, waiting for 5 min-
utes and then reconnecting the AC Power Cord.
Reset All ?
Yes No
Figure 39
Yes No
Reset Lamp Life ?
Figure 38
Lamp Life 5 Hours
Warning
Figure 36
Lamp Life 0 Hours
Warning
Figure 37
Warning
Lamp Life 100 Hours
Figure 35
Figure 34
Information
Video Input HDMI 1 - 1080p
Picture Mode User 1
Gamma A
Aspect Normal
Lamp Mode Economy
Iris F6.0
Lamp Life 921 Hours
Total Time 3653 Hours