M-AUDIO Studiophile BX5 - Manual (Page 12)

Appendix A - Technical Specifications
Type: Two-way studio reference
LF Driver: 5-inch dia., magnetically-shielded with curved mineral-filled
polypropylene cone, high temperature voice coil and damped rubber
surround
HF Driver: 1-inch dia., magnetically-shielded with natural silk dome
Frequency Response: 56Hz - 20kHz
Crossover Frequency: 3.0kHz
LF Amplifier Power: 38W
HF Amplifier Power: 38W
S/N Ratio: >100dB below full output, 20kHz bandwidth
Input Connectors: One XLR balanced input connector; one TRS
balanced/unbalanced input connector
Polarity: Positive signal at + input produces outward low-frequency
cone displacement
Input Impedance: 20k ohms balanced, 10k ohms unbalanced
Input Sensitivity: 85 mV pink noise input produces 90dBA output SPL at 1
meter with volume control at maximum
Acoustic Space Control: 0dB, -2dB, -4dB
High Frequency Control: -2dB, 0dB, +2dB
Mid-Boost Control: In, Out
Low Cut-off Frequencies: 56Hz, 80Hz, 100Hz
Protection: RF interference, output current limiting, over temperature, turn
on/off transient, subsonic filter, external main fuse
Indicator: Blue power on/off indicator on front panel
Power Requirements: Dual-voltage (selectable by rear-panel switch) for
either 115V/~60Hz, 230V/~50Hz; powered via detachable 3-circuit line cord
Cabinet: vinyl-laminated MDF
Dimension: 250 mm (H) x 166 mm (W) x 200 mm (D)
Weight: 5kg/unit (without packing)
* Above specifications subject to change without notice
12
Tested to
comply
with FCC
Standards
For Home or Studio Use