Matsushita CF-19FHGAX - Manual (Page 39)

■ Line Processing of Antenna Cable and LCD Cable
Insert the cables into the Cable Holder as shown in figure.
<CAUTION>:Position of the Antenna Cables
Right side of LCD Cable:White/Gray
Left side of LCD Cable:Blue/Black/Brown
Install the Holder and Cable guide on the Hinge as shown in figure.
Step1 Step2
Cable Guide HInge
Cable Holder
Cable Holder
S1:Insulation S2:Pinching Cables S3:Sharp Edge
S4:Part No. Check S5:Others
Safety Working
CAUTION
Step3
Step6
OK
NG
S2
S5
CAUTION:Check the position of the Cables
Step4
Step5
S5
Keep margin in cable length
Fit Holders as shown in figure
(Until you hear the click)
Red marking is
on the holder
Black marking is
on the holder
Watch out is the cable comes off from the holder
for cable is not scissored between the holder and hinge.
Next, wrap (one round) the LCD Cable around
the axis of the Hinge as shown in figure.
It prevents to break of the cable
LCD cable proccess space
ANT cable proccess space
Wrap (one round) only the Antenna Cables around
the axis of the Hinge as shown in figure.
Note: Handle LCD cable as show in figure. LCD cable
must not intersect with Antenna Cables.
It prevents to
break of the
cable
The antenna cables must not intersect with the LCD cable.