Mitel WRV54G - Manual (Page 21)

11 Chapter 5: Connecting the Wireless-G VPN Broadband Router
Overview
Wireless-G VPN Broadband Router
Chapter 5: Connecting the Wireless-G VPN Broadband Router
Overview
To begin installation of the Router, you will connect the Router to your PCs, other network devices, and cable or
DSL modem. If you want to use a PC with an Ethernet adapter to configure the Router, continue to “Wired
Connection to a PC.” If you want to use a PC with a wireless adapter to configure the Router, continue to “Wireless
Connection to a PC.”
Wired Connection to a PC
1. Make sure that all of your network’s hardware is powered off, including the Router, PCs, and cable or DSL
modem.
2. Connect one end of an Ethernet network cable to one of the LAN ports (labeled 1-4) on the back of the Router.
Then connect the other end to an Ethernet port on a PC.
3. Repeat step 2 to connect additional PCs or other network devices to the Router.
4. Connect a different Ethernet network cable from your cable or DSL modem to the Internet port on the Router’s
rear panel.
5. Power on the cable or DSL modem.
6. Connect the power adapter to the Router’s Power port, and then plug the power adapter into a power outlet.
The Power LED on the front panel will light up green as soon as the power adapter is connected properly. The
Power LED will flash for a few seconds, and then it will be solidly lit when the self-test is complete. If the LED
flashes for one minute or longer, see “Appendix A: Troubleshooting.”
7. Power on one of your PCs that is connected to the Router.
The Router’s hardware installation is now complete.
Go to “Chapter 6: Configuring the Wireless-G VPN Broadband Router.”
Figure 5-2: Connect to Internet Port
Figure 5-1: Connect to LAN Ports
Figure 5-3: Connect to Power Port
NOTE: You should always plug the Router’s power adapter into a power strip with surge protection.