Motorola SBV4200 - Manual (Page 15)

10 SURFboard ® SBV4200 VoIP Cable Modem User Guide
Cabling and Startup for a Single User, continued
Introduction Before You Begin Installation & Configuration FAQ Troubleshooting Glossary License
X
Home Print Exit
6 Connect your computer to the VoIP cable modem using USB or Ethernet:
USB: Be sure the SURFboard VoIP Cable Modem CD-ROM is inserted in your
CD-ROM drive. Connect the USB cable to the USB port on the VoIP cable modem.
Connect the other end to the USB port on your computer. Then perform
“Setting Up
a USB Driver” on page 11.
Ethernet: Connect the provided straight-through Ethernet cable to the Ethernet
connector on the VoIP cable modem. Connect the other end to the Ethernet port on
your computer. Ethernet users do not need to set up USB.
7 Perform the procedures for “Configuring TCP/IP” on page 22.
8 To connect the telephone line, plug a phone wire into the phone 1 connector. You
can also connect a second telephone line to the phone 2 connector.
Caution
Contact your cable service provider before connecting your VoIP cable
modem to your existing telephone wiring. Do not connect the telephone
wire to a traditional telephone (
PSTN ) service.
Be sure the phone connectors are neither connected together nor
connected to wall jacks on the same network.
P/ N: AA A AA A- BB B- 0 0 Ma de in . ... .. ...
C M HFC MA C ID : A B CD EF0 12 3 45
C USTO MER S/ N: B CD FG HJ KLMN P
S/ N: PP PPMMY JJ J SSSS SCA A BB CC CC
U SB CPE MA C ID: A BC DE F01 2 34 5
MTA MA C ID : AB CD EF0 12 3 45
Caution
Do not connect both the Ethernet
and USB cables to the same
computer.
Computer SURFboard VoIP
cable modem
Connect to either
Ethernet or USB