Motorola SBV4200 - Manual (Page 47)

42
Introduction Before You Begin Installation & Configuration FAQ Troubleshooting Glossary License
42 SURFboard ® SBV4200 VoIP Cable Modem User Guide X
Home Print Exit
Cannot send or receive data Check the lights on the front panel. Note the first light from top to bottom that is off. This light indicates where
the error occurred as described in
“Front-Panel Lights and Error Conditions” on page 43.
If all lights are off except the Standby light, the VoIP cable modem is in Standby mode. Press the Standby button
to reconnect your Internet service.
If you have cable TV, check that your TV is working and the picture is clear. If you cannot receive your regular
TV channels, your data service will not function.
Check the coaxial cable at the VoIP cable modem and wall outlet. Hand-tighten if necessary.
Check the IP address. Follow the steps in “Verifying the IP Address in Windows 95, 98, or Me” on page 36 or
“Verifying the IP Address in Windows 2000 or XP” on page 37. Call your cable service provider if you need an
IP address.
Check that the USB or Ethernet cable is properly connected to the VoIP cable modem and your computer.
Problems related to unsuccessful
USB driver installation Remove the USB driver. Follow the instructions in one of:
■ “Removing the USB Driver from Windows 98 or Me” on page 44
■ “Removing the USB Driver from Windows 2000” on page 48
■ “Removing the USB Driver from Windows XP” on page 53
Problem Possible Solutions