Motorola MPC5200 - Manual (Page 27)

MPC5200 FEC Device Driver KADAK M5200E-5
MPC5200 FEC Ethernet
Device Driver Data Sheet (continued)
Porting the MPC5200 FEC Ethernet Device Driver
The KwikNet MPC5200 FEC Ethernet Device Driver is ready for use on the Motorola
Lite5200 Evaluation Board. The default board driver module KN_BOARD.C provided with
KwikNet is also ready for use with this board.
To port this device driver to your MPC5200 hardware, proceed as follows. Review
header file
M5200E.H and be sure that the symbols defined at the beginning of the file
match your intended MPC5200 use. Alterations will be required in only the rarest of
configurations.
If you are using AMX PPC 32 , you can use Interrupt Identification Procedure ch500vd()
in the AMX board support module, LITE5200.S , to derive the AMX vector number for
the interrupting devices.