Motion Computing M1200 - Manual (Page 22)

Chapter
2 Motion M1200 and M1300 Tablet PC Hardware
Motion Computing M1200 and M1300 Tablet PC User Guide 19
A CCESSORIES You can order the following accessories from the Motion Computing
website at www.motioncomputing.com/accessories.
NOTE: You can order the Motion M-Series FlexDock, batteries, and Digitizer
Pens from Motion Computing.
Motion M-Series Desktop Stand
The Motion M-Series Desktop Stand is an easel-like device that holds either
Tablet PC in portrait or landscape mode. You can open the desktop stand to
different widths to change the display angle: the wider you open the stand,
the less the Tablet PCs will tilt back.
Some connectors may be awkwardly located when the Tablet PC is in the
Desktop Stand. If you regularly connect several accessories to your Tablet
PC, consider obtaining a Motion M-Series FlexDock.
Motion M-Series FlexDock
The Motion M-Series FlexDock is a desktop docking station that provides a
convenient interface at your desktop for either Tablet PC. It contains
interfaces for RJ-45/Ethernet, three USB connectors, an IEEE 1394
connector, headphone and microphone jacks, and a VGA monitor connector.
These are shown in the diagram below.
• Easily docks and undocks with both Tablet PCs
• Adjusts to support the display from 0
o
- 90
o
for viewing and writing
• Automatically adjusts the display when you rotate the Tablet PC 90
o
between Primary Landscape and Primary Portrait
• “Grab-and-Go” capability lets you safely remove the Tablet PC from
the FlexDock without turning the system off or putting it in Stand By
mode
NOTE: For more information about installing the FlexDock, see Chapter 4 of this
User Guide or the Installation Card packaged with the FlexDock.
External
Monitor
RJ-45/
Ethernet
USB
AC Power Jack
IEEE 1394
Audio-in/
Microphone
Jack USB
Front
Motion M-Series FlexDock
Back
Audio-out/
Headphone
Jack
USB