Motion Computing M1200 - Manual (Page 48)

Chapter 4 Using Your Motion M1200 and M1300 Tablet PCs
Motion Computing M1200 and M1300 Tablet PC User Guide 45
A DDING
M EMORY TO
I MPROVE
S YSTEM
P ERFORMANCE
AND I NCREASE
B ATTERY L IFE
Use only Motion M-Series Memory modules obtained from Motion
Computing to upgrade the factory-installed memory.
WARNING: To avoid the risk of personal injury or damage to the Tablet
PC, when performing the following tasks, turn off your Tablet PC, unplug
the AC power connection, and remove the battery. Ground yourself by
touching a grounded conductive surface, such as a device or appliance
with a grounded, three-pronged plug. Avoid touching the pins and leads
on the memory module and the internal circuitry of the Tablet PC.
1. After you disconnect power, unscrew the L-
shaped cover from the bottom of the Tablet PC.
2. If you are replacing a module, release the clips
on each side of the module and lift to remove it.
3. Align the pins on the Memory Upgrade module
with the receptors on the slot.
4. Gently push the new module into the slot at a
25-degree angle until it is firmly seated; then rotate it into place.
5. Replace the external cover and install the two screws.
6. To check that the Memory Upgrade has been properly installed,
select Start, My Computer, View System Information. The General
tab shows the amount of RAM (memory) installed in your system.
NOTE: If the amount of RAM shown and the actual RAM differ, the Memory
Upgrade module may not be seated properly. Repeat Steps 1-5, taking care to
re-seat the module correctly.
Supported Memory Configurations for Motion M1200
Base Memory-Slot A* Base Upgrade-Slot B* Total Memory
256MB 256MB 512MB
512MB 768MB
512MB 256MB 768MB
512MB 1GB
* PC133 SDRAM SODIMM
Note: The Motion M1200 has Base Memory factory-installed in Slot A. You can
install/reinstall memory modules in either Slot A or B for best performance.
Supported Memory Configurations for Motion M1200
Base Memory-Slot A** Base Upgrade-Slot B** Total Memory
256MB 256MB 512MB
512MB 768MB
256MB 512MB 768MB
512MB 1GB
** PC266 DDR SODIMM
Note: The Motion M1300 has Based Memory factory-installed in Slot B. If you
install/reinstall only a single memory module in the M1300, always install it in
Slot B for best performance.