Magnadyne M5000CD - Manual (Page 4)

4
Radio Operation
Listening to the Radio
1. Push the “POWER” button (1) once to turn the unit on.
2. Press the “BAND” button (12) to select a radio
band: FM1, FM2, AM or WX (weather band).
3. AM or FM Station Selection
Automatic Seek Station Selection: Press the
or button (5) to automatically seek the
next strong station.
Scan Station Selection: Press the button
(4) to automatically scan through strong sta-
tions in the current radio band. The radio will
pause for 5 seconds at each strong station.
Each frequency will flash in the display. Press
the scan button again to hold the current station.
Manual Station Selection: Press the or
button for more than 3 seconds to manually
select stations, and "MAN" will appear in the dis-
play. Use either button to manually seek up and
down the frequency scale.
Note: If either button is not pressed for several
seconds, the unit will return to Automatic Seek
Station selection and "AUTO" will appear in the
display.
Weather Band Station Selection (WX)
Press the “BAND” button four times to select
WX, then use the or button to manually
seek the stations.
Sound Controls
Programming the Radio
You can program up to 20 FM radio stations and 10 AM
radio stations.
Manual Station Recall Programming
1. Press the “BAND” button (12) to select a radio
band: FM1, FM2, or AM.
2. Select the desired station.
3. Press and hold one of the ten station recall but-
tons (6-11), the button number and "CH" will
appears in the display area. Release the button.
4. Repeat the Steps 1-3 to memorize additional sta-
tions as desired.
Automatic Station Store
1. Press the “BAND” button (12) to select a radio
band: FM1, FM2 or AM.
2. Press the button (14) for more than 2 sec-
onds, the radio will then search the current fre-
quency and check the signal strength until the six
strongest stations are stored into the correspond-
ing preset number button. When completed, the
system will scan the stored stations automatically.
Preset Scan
Press the button (14) to scan the preset sta-
tions. The radio will hold at that preset number for
several seconds, then will scan again. To stop
scanning when a desired station is reached press
the button again.
Adjusting the Volume, Bass Treble, Balance and
Fader
1. Press the button (2) to select the desired
audio mode. The audio modes will be displayed in
the following order: Volume, Bass, Treble,
Balance and Fader.
2. Press the or buttons (5) to adjust the
sound of the audio mode selected.
Initial Volume Level
To program the Initial Volume Level, adjust the
volume to the desired level, then press the
"POWER" button for more than 3 seconds. The
next time the unit is turned on, the volume will be
at this initial level.
Adjusting the Audio Beep
Press the button for more then 2 seconds
to turn beep On/Off. When the beep is on the
icon will be displayed.
Adjusting the Loud Feature
Press the LOUD button (15) to increase the bass
and treble output, "LOUD" will then be displayed.
Press the button again to release this function.
Mute
In Radio/Aux In mode, press the button (18)
mute audio level. Press the button again to
release this function.
MUTE
AS/PS
AS/PS
AS/PS
SCAN