Consumables, For m-25 gun, Drive rolls – Miller Electric Millermatic 212 User Manual
Page 6
6
For M-25 Gun
Contact Tips
#087 299 .023/.025 in. (0.6 mm)
#000 067 .030 in. (0.8 mm)
#000 068 .035 in. (0.9 mm)
#000 069 .045 in. (1.1 mm)
#187 117 .035 in. (0.9 mm) heavy-duty tip
#187 118 .045 in. (1.2 mm) heavy-duty tip
Tapered Contact Tips
#176 797 .030 in. (0.8 mm)
#176 793 .035 in. (0.9 mm)
#176 794 .045 in. (1.2 mm)
Contact Tip Adapter #169 728
Replacement Liners
#194 010 .023/.025 in.
#194 011 .030 –.035 in. (standard)
#194 012 .035 –.045 in.
Nozzles
Note: Flush or stickout nozzles should be used for
the short-circuit process.
#200 258 Standard
1/2-inch (13 mm) diameter orifice. Nozzle
flush with contact tip.
#169 726
5/8-inch (16 mm) diameter orifice.
Nozzle flush with contact tip.
#169 727
5/8-inch (16 mm) diameter orifice. Contact
tip sticks out of nozzle 1/8 inch (3.2 mm).
#169 724
1/2-inch (13 mm) diameter orifice. Contact
tip recessed 1/8 inch (3.2 mm) into nozzle.
#169 725
5/8-inch (16 mm) diameter orifice. Contact
tip recessed 1/8 inch (3.2 mm) into nozzle.
Tapered Nozzles
Note: Tapered tips are recommended when using a
tapered nozzle.
#176 243
3/8-inch (9.5 mm) diameter orifice.
#178 386
11/32-inch (8.7 mm) diameter orifice.
M-Series Consumable Kits
#234 610 .030 in. (0.8 mm)
#234 611 .035 in. (0.9 mm)
#234 612 .045 in. (1.2 mm)
Contains ten contact tips, one nozzle, one
contact tip adapter and one nozzle adapter.
Drive Rolls
Note: Drive roll kits include two drive rolls and an
inlet guide.
V-Grooved Drive Roll Kits (solid wire)
#204 579 .030 and .035 in.
(0.8 and 0.9 mm)
combination (reversible)
#087 131 .023/.025 in. (0.6 mm)
#079 594 .030 in. (0.8 mm)
#079 595 .035 in. (0.9 mm)
V-Knurled Drive Roll Kits
(flux-cored or difficult-to-feed wire)
#079 606 .035 in. (0.9 mm)
Consumables
(Order from Miller Service Parts.)