Motorola i2000 - Manual (Page 76)

74
www.nextel.com
Displaying Your Private ID
Using the Private/Group Speaker
You can enable or disable the speaker on your i2000 phone for Direct Connect
use. When the speaker is on, the caller’s voice can be heard over the speaker.
When the speaker is off, the caller’s voice can only be heard through the
earpiece of your phone.
Turning the Speaker On
Turning the Speaker Off
Placing Private Calls
From Private Mode, there are also two ways to reach an individual using Direct
Connect. You can enter the person’s Private ID number then press the Push-To-
Talk button. Or, you can store the person’s name and private ID number, then
recall the number from a stored list. Whether you dial the person’s private ID
directly or store it in a list--you must have the individual’s private ID to use
Direct Connect. To learn how to store names and numbers, see “Storing Names
and Numbers” on page 26 if you haven’t done so already.
Entering the Private ID
1 Press n until you see the “Prgm” menu selection.
2 Press o under “Prgm” and press 2 .
3 Press o under “Exit”.
Press k .
Press k . p will appear on your display. A brief alert tone will notify
you of incoming Private or Group calls.
1 Press m until you see Prvt Ready.
2 Enter the Private ID.
3 Press and hold the Push-To-Talk button on the side of the phone to talk.
Both phones will chirp before your voice can be heard.
4 Release the Push-To-Talk button to listen.