MartinLogan Vignette On-Wall/Off-Wall Loudspeaker - Manual (Page 12)

9 Place the Vignette onto the wall bracket and carefully
slide the Vignette into place (see figure 23).
10 Using a 6mm Allen tool, attach a washer and cap nut
onto each pin. Do not fully tighten the cap nuts (see fig-
ure 23).
11 Make the signal connections from the amplifier (see
‘Operation’, pages 4).
12 Rotate the Vignette to point at the listening position and
tighten the cap nuts (see figure 24).
13 Rotate the Vignette’s logo medallion, by removing the
grill cloth cover, gently pressing the medallion from
behind and turning it to the correct orientation (see fig-
ure 25).
12 Mounting the Vignette On A Wall or Ceiling
Figure 23. Install the Vignette and the washers and cap nuts. Figure 24. Rotate the Vignette into position and tighten the cap nuts.
Figure 25. Rotate the Vignette’s logo medallion so it is correctly orientated.