MartinLogan Vignette On-Wall/Off-Wall Loudspeaker - Manual (Page 7)

Required tools (included):
2.5mm Allen tool, 6mm Allen tool
NOTE: This procedure can be performed either with the
bracket assembly installed on the Vignette cabinet or with
the bracket assembly uninstalled. For the purpose of illus-
trating this procedure, the bracket assembly is depicted
installed on a cabinet.
1 Ignore this step if the bracket assembly is not installed on
the Vignette. Prepare a flat surface with padding and sheets
to protect the speaker as you work on it. Remove the
Vignette's grill cover and carefully place the Vignette face
down on the work surface, using books or pieces of card-
board to keep the speaker from rocking.
2 Using the 6mm Allen tool, remove the 2 cap nuts and wash-
ers from the hinges. Place them aside (see figure 7).
3 Carefully remove the wall bracket from the cabinet bracket
(see figure 8).
4 Using the 2.5mm Allen tool, carefully remove the 2 set
screws that hold the 2 hinge pins in place (see figure 9).
5 Move the wall bracket hinge pin to the outside of the
opposite hinge. Move the cabinet bracket hinge pin to
the outside of the opposite hinge (see figure 10).
6 Using the 2.5mm Allen tool, reinstall the 2 set screws to
lock the hinge pins in place. Make sure the set screw tight-
ens against the flat surface of the pin (see figure 11).
7 Reinstall the washers and cap nuts.
Changing the Direction of Rotation
Figure 7. Remove the 2 cap nuts and washers from the hinges.
Figure 8. Remove the wall bracket from the cabinet bracket.
Figure 9. Remove the 2 set screws.
Figure 10. Change hinge pin locations.
Figure 11. Reinstall the two set screws to hold hinge pins in place.
Mounting the Vignette On A Wall or Ceiling 7