Maretron TMP100 Exhaust Gas Temperature Probe TP-EGT-1 - Manual (Page 5)

® ®
Revision 1.0 Page 1
1 Introduction
Congratulations on your purchase of the Maretron Temperature Module. Maretron has
designed and built your TMP100 to the highest standards for years of dependable and
accurate service.
Maretron's TMP100 measures the temperature for up to 6 temperature probes and reports the
information over an NMEA 2000
® network. The TMP100 supports up to 4 thermistor probes
and 2 high temperature thermocouple probes. Optional thermistor probes (-20°C to 80°C or -
4°F to 176°F) cover a wide range of applications including cabin air temperature, engine room
air temperature, refrigerator/freezer temperature, under bolt temperature (inverters, charges,
pumps, motors, etc.), tank temperatures (live well bait, hot water, etc.), and air duct
temperatures. The optional thermocouple probes (0°C to 900°C or 32° to 1652°F) are used to
measure Exhaust Gas Temperature (EGT) as part of a comprehensive fuel management
system.
The Maretron TMP100 is designed to operate within the harsh demands of the marine
environment. However, no piece of marine electronic equipment can function properly unless
installed, configured, and maintained in the correct manner. Please read carefully and follow
these instructions for installation, configuration, and usage of the Maretron TMP100 in order to
ensure optimal performance.
1.1 Firmware Revision
This manual corresponds to TMP100 firmware revision 1.0.3.
1.2 TMP100 Features
The Maretron TMP100 has the following features.
• NMEA 2000 ® Interface
• Waterproof Connectors
• Sealed Waterproof Enclosure
• Opto-Isolated from NMEA 2000 ® Eliminating Potential Ground Loops
• Six External Temperature Probes are Measured and Broadcast Over NMEA 2000 ®
Network
• Four Channels for Thermistor Probes and 2 Channels for High Temperature
Thermocouple Probes
• Wide Variety of Applications Supported with Optional Temperature Probes
- Cabin Temperature
- Engine Room Temperature
- Under Bolt Temperature (Inverters, Chargers, Pumps, etc.)
- Refrigerator/Freezer
Temperature
- Tank Temperatures (Live Well Bait, Hot Water, etc.)
- Air Duct Temperature
- Exhaust Gas Temperature
- User Defined Temperature Types (#129-#144)
• Optional Temperature Probes