MaxTech xps336ir V.34/V.42bis - Manual (Page 13)

11
d=300-28800. A, b, c, d default=11, 1,
300, 28800. Parameter “a” specifies the
modulation protocol desired where: 0=V.21,
1=V.22, 2=V.22bis, 3=V.23, 9=V.32,
10=V.32bis, 11=V.34, 64=Bell 103,
69=Bell 212, and 74=VFC. Parameter “b”
specifies automode operations where:
0=automode disabled, 1= automode
enabled with V.8/V.32 Annex A. Parameter
“c” specifies the minimum connection data
rate (300-28800). Parameter “d” specifies
the maximum connection rate (300-28800).
#CID=n n=0 Disable Caller ID
n=1 Enables Caller ID with formatting (date,
time, number, name)
n=2 Enables Caller ID without formatting
#CID? Displays current Caller ID mode
#CID=? Returns Caller ID capabilities of modem.
3.5 MNP/V.42/V.42bis Commands
%C_ %C0 Disable MNP Class 5 and V.42bis data
compression
%C1 Enable MNP Class 5 data compression
only
%C2 Enable V.42bis data compression only
%C3 Enable MNP Class 5 and V.42bis data
compression
&Q_ &Q0 Direct data link only (same as \N1)
&Q5 V.42 data link with fallback options
&Q6 Normal data link only (same as \N0)
\A_ \A0 64-character maximum MNP block size
\A1 128-character maximum MNP block
size
\A2 192-character maximum MNP block size
\A3 256-character maximum MNP block size
\Bn Send a 1/10 second line break to the modem,
where n = 1 to 9. At normal connect, the default
is 3
\Kn Set break control, where n= 0 to 2. The effect of
this command depends on the modem’s operating
condition. Default is 1.
\N_ \N0 Normal data-link only
\N1 Direct data-link only