MHP TJK - Manual (Page 12)

12
Mountings
Built-in Kit Mounting
Assembly Instructions (NMS)
•
The JNR, WNK or TJK model grills may be
mounted as a built-in.
•
For use with natural or hard–plumbed propane
gas.
•
Use of the Built-in kit for LPG poses a safety
risk and voids any and all warranty.
•
Enclosure must be constructed from non com-
bustible materials.
•
The Built-In kit and grill head connection will
be assembled upside down.
•
Refer to appropriate section for grill head as-
sembly.
Please check to be sure that all parts are included be-
fore proceeding. Contact your dealer if any parts are
missing.
Parts Quantity
Set of doors with magnetic catches
Consisting of:
Frame for Door Set 1
Left Hand Door 1
Right Hand Door 1
Heat Shield 1
Magnetic Catches 2
Door Handles 2
Front Face Plate for NMS ( 26" W x 11" H x 1½" D) 1
Right Side “L” Bracket 19" x 11" 1
Left Side “L” Bracket 19" x 11" 1
Rear Support Bracket 26
1/8 " long 1
Grease Tray 1
Hardware Kit
¼ - 20 x
¾ " Hex lts 12
¼ - 20 x 1 ¼" Hex Bolts 4
¼" Nuts 4
¼" Flat Washers 4
¼" Lock Washers 16
Important Notes:
Your structure should have a 3" to 4" concrete base on a
sand footing.
The panel doors must have a 4" to 6" minimum elevation
from the ground.
If your structure includes a back splash, allow 11" to the
back edge of grill opening to allow the lid to open com-
pletely.
Combustible material should never be within 24 inches of
the top, bottom, back or sides of your Grill
.
Complete View Of Built-In
Step 1: Required Dimensions For Built-In
(Fig. 16)
1. The grill head fits into an opening of 27½" wide by
10¾" high by 18" deep.
2. The Panel doors fit into an opening of 27¼" wide by
16¾" tall.
3. The side burner fits a surface opening of 10¼" wide
by 11¾" front to back. It should be at least 5" away
from the grill opening.
(The front face flanges on the mounting and the panel
doors overlap the required opening surfaces by 1
5/8 "
and provide a clean look.)
12