MHP TJK - Manual (Page 7)

7
Mountings
For Natural Gas Models
(
Note: Tank Holder Ring is not included with natural
gas models.)
If the grill is to use natural gas from the supplied 12-
foot hose: the hose must pass through the hose
clamp (See Fig. 1). The hose will have a quick-
disconnect fitting at the source and the source will
have a gas shut off valve with easy access.
Step 3: Tank Holder Ring Assembly For LP
Gas Models (Fig. 4)
1. The L.P. Tank Holder Ring Connects to the lower
shelf cross frame with the ring notches resting on
the axle frame.
2. Align the rear tank ring-fitting hole over the lower
cross frame hole. Insert a ¼ - 20 x 5/8" slotted bolt
through the top and fasten with a ¼ - Kep nut
from below.
3. Fasten the thumb screw (¼- 20 x ¾") to the tank
ring fitting with the ¼ - 20 Hex nuts. The Hex nut
slips into the captive slot on the tank ring fitting.
4. Use a ¼ - 20 x 1½" slotted bolt and a ¼ - 20 Kep
nut to connect the tank holder flanges together.
Deck/Patio Mounting
Assembly Instructions (MPB)
•
Either the JNR or WNK model grills may be
mounted on the Deck/Patio base.
•
The gas supply may be either LP or Natural.
•
The grill head bottom should not be attached
to the post until the mount is fasten to a
deck/patio.
Please check to be sure that all parts are included
before proceeding. Contact your dealer if any parts
are missing.
Parts Quantity
2' Post 1
Patio Base 1
Post Access Door 1
Grease Cup Holder 1
28” Stainless Steel Tubing 1
Stainless Steel Grease Cup 1
Hardware Kit
¼ - 20 x ¾" Hex Head Bolts 7
¼ - 20 Kep Nuts 7
¼" Flat Washers 7
8 - 32 x ½" Self Tapping Screw 1
Tube Clip 1
When you have completed the mount assembly
go to the appropriate Grill Assembly Section and
assemble the grill head.
Continue on following page. ! ! ! !
Caution: Combustible material should never be
within 24 inches of the top, bottom, back or
sides of your MHP Gas Barbecue Grill.
Fig. 3