MITSUBISHI ELECTRIC WS-48515 - Manual (Page 9)

8 9
Front Control Panel
SYSTEM RESET
If the TV will not respond to either the remote control
or the front panel controls and/or will not power Off,
press the SYSTEM RESET button with a pointed item
like the end point of a paperclip. The TV will turn Off
and the TIMER light will flash quickly for about one
minute. When the TIMER light stops flashing, you may
turn on the TV again. Changes you made the last time
the TV was On before you used the SYSTEM RESET
button may be lost, however, the changes you made
previously are not lost.
POWER/TIMER Indicator
The green light is a multi-function indicator. This light
will flash rapidly for about one minute each time the TV
is plugged into the wall electrical outlet, when power
is restored after a power failure, or using the SYSTEM
RESET button. Do not attempt to turn on the TV again
during this period. Wait for the flashing to stop and
the light to turn off, before attempting to turn the TV
on. While the TV is powered on, the light illuminates
steadily. If the TV has been programmed to turn on
automatically using the Timer feature, this light will flash
slowly when the TV is powered off.
Except for SYSTEM RESET and TIMER, all of the buttons on the Front Control Panel (highlighted in gray) are
duplicated on the remote control. The top row of labels show the control functions when there are no TV menus
displayed on the screen. The bottom row of labels show the control functions when the TV menus are displayed on
the screen or when a special function has been activated. See Remote Control Overview page 29, for further details
on the functions of these buttons. TIMER is also accessible through the menu screens. Pressing MENU on the front
panel will display the TV menu.
INPUT– 3
POWER DEVICE
ENTER ADJUST ADJUST CANCEL MENU
VOL CH FORMAT
SYSTEM
RESET
TIMER
MENU S-VIDEO VIDEO L – AUDIO – R
Front Panel WS-48515, WS-55515, WS-65515, WS-65515A
DEVICE
CANCEL MENU ENTER
MENU FORMAT CH VOL POWER
SYSTEM
RESET
TIMER ADJUST
s r
v w
s r
s r ADJUST
Front Panel WS-55615, WS-55615A, WS-65615, WS-65615A, WS-73615
GUIDE
GUIDE
INPUT-3
S-VIDEO VIDEO L-AUDIO-R
IEEE 1394
A/V RESET
There may be times when you wish to reset the A/V
(Audio and Video) settings back to the factory defaults.
To do this for an individual setting, use the Audio
or Video remote control button. To return all of the
settings at once, press GUIDE and FORMAT on the
front panel at the same time, or use the A/V Memory
Reset selection on the AudioVideo menu (page 68).
INPUT 3
This input can be used for convenient connection of
a camcorder or other video device to the TV. If you
connect to the S-VIDEO terminal, the VIDEO terminal
is deactivated. The VIDEO terminal is available when
there is no S-Video connection.
IEEE 1394
(WS-55615, WS-55615A, WS-65615,
WS-65615A, WS-73615 only)
This IEEE 1394 (FireWire®) input/output allows for
temporary connection of IEEE 1394 devices such as
MPEG 2 camcorders or compatible hard disc drives to
the front of the TV. This connection works the same
way as the two rear IEEE 1394 connections.