Moxa Technologies THINKCORE W315 - Manual (Page 25)

A A
Appendix A
FCC Warning Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that may cause
undesired operation.
This equipment has been tested and found to comply with the limits for a class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy, and if not installed and
used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
y Reorient or relocate the receiving antenna.
y Increase the separation between the equipment and receiver.
y Connect the equipment to an outlet on a circuit different from that to which the receiver is
connected.
y Consult the dealer or an experienced radio/TV technician for help.
CAUTION:
Any changes or modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
Prohibition of co-location:
This device and its antenna(s) must not be co-located or operating in conjunction with any other
antenna or transmitter.
Safety Information:
To maintain compliance with the FCC’s RF exposure guidelines, when installing and/or operating
this equipment, you should maintain a minimum distance of 20 cm between the transmitter and
your body. Use only the supplied antenna. Unauthorized antennae, modifications, or attachments
could damage the transmitter and may violate FCC regulations. The device includes a GPRS
module. This module has approved by FCC. The FCC ID is 09EQ24PL001