MaxTech xpvs336i - Manual (Page 12)

10
&P2 Same as &P0 setting but at 20 pulses per
minute
&P3 Same as &P1 setting but at 20 pulses per
minute
&R_ &R0 Reserved
&R1 CTS operates per flow control
requirements
&S_ &S0 Force DSR Signal High (ON)
&S1 DSR off in command mode, on in on-line
mode
&T_ &T0 Ends test in progress
&T1 Perform Local Analog Loopback Test
&T3 Perform Local Digital Loopback Test
&T4 Grant Remote Digital Loopback Test
request by remote modem
&T5 Deny Remote Digital Loopback Test
request
&T6 Perform a Remote Digital Loopback Test
&T7 Perform a Remote Digital Loopback Test
and Self-Test
&T8 Perform Local Analog Loopback Test and
Self-Test
&V &V Displays Active and Stored Profiles
&W_ &W0 Stores the active profile as Profile 0
&W1 Stores the active profile as Profile 1
&Y_ &Y0 Configuration Profile 0 active upon
Power on or reset
&Y1 Configuration Profile 1 active upon Power
on or reset
&Z n=x n=0-3 Store phone number x into non-volatile
RAM
%E_ %E0 Disable auto-retrain
%E1 Enable auto-retrain
%L Display line signal level
%Q Display line signal quality
+MS? Displays the current Select Modulation
settings
+MS=? Displays a list of supported Select
Modulation options
+MS=a,b,c,d Select modulation where: a=0, 1, 2, 9, 10,
11, 64, 69, 74; b=0-1; c=300-33600; and
d=300-33600. A, b, c, d default=11, 1,