Preheating the coffee maker, Cleaning and maintenance, Frothing tips – Morphy Richards Pump action espresso User Manual

Page 6: Hot water drinks

Advertising
background image

6

Frothing tips

• For best results use fresh, cold milk from

the refrigerator.

• Skimmed milk or fat reduced milk will

make frothing easier.

• Use a stainless steel jug.

Hot water drinks

You are able to make hot water drinks

such as tea or instant soups using the
steam nozzle.
1 Ensure the unit is cold before removing

the froth attachment from the steam
nozzle if attached.

2 Follow the ‘steam function’ and heat up

hot water instead of milk.

Note: It is normal for the orange ‘warm

up light’ to cycle on and off during the
water heat up process.

Preheating the coffee
maker

To make hotter coffee you may preheat

our machine. This can be achieved by
following the ‘espresso operation’ by
passing water through the coffee maker but
without using coffee.
• Never use warm or hot water to fill the

water tank.

Cleaning and
maintenance

You must clean the steam nozzle and

froth attachment immediately after each
use.
1 Simply wipe the steam nozzle, cup tray

and exterior with a clean, damp cloth.
Do not use any abrasives or metal
scourers as this will damage the finish
on the unit.

2 Briefly run steam through the nozzle

(follow the directions under ‘steam
function’, to clear any remaining milk out
of the steam nozzle.

WARNING: Steam from the nozzle is

extremely hot and can scald.
3
Place the froth attachment under running

water to remove any excess milk.

4 The filter, filter holder and water tank

should be washed after each use by
rinsing them under warm water. To assist
in keeping the filters clean we
recommend you periodically run the
machine with the filter in place, without
coffee, using water only.

5 Lift out the drip tray and wash under the

tap. Ensure it is dry before refitting.

L

Should the holes in the filters become

blocked with coffee granules use a fine
bristled brush.

When your coffee maker is not being

used, we recommend that you do not leave
the filter holder attached to the machine as
this will reduce the life of the gasket.

NO PARTS ARE SUITABLE FOR

CLEANING IN A DISHWASHER.

L

47570 Rev 1 25/6/04 4:57 PM Page 6

Advertising