Miller Electric CP-202 - Manual (Page 17)

OM-259 Page 13
2-7. Inductance Selection (200 And 300 Ampere Models)
1 Stabilizer Z
Tapped stabilizer Z is factory
connected to the stabilizer tap
which suits most GMAW
applications.
Stabilizer Z controls the inductance
applied to the weld current. To in-
crease inductance and wet out the
weld puddle, connect to stabilizer Z
ending.
To change inductance proceed as
follows:
2 Lead 25
3 Stabilizer Z Tap
4 Stabilizer Z Ending
5 Lead 26
To increase inductance, connect
lead 26 to stabilizer ending and
secure.
Reinstall side panel.
6 Typical Weld Bead Using The
Tap Stabilizer Connection
Use the tap Stabilizer connection to
obtain arc type and weld bead suit-
able for some mild steel applica-
tions.
7 Typical Weld Bead Using The
End High Stabilizer
Connection
Use the end Stabilizer connection
to reduce weld bead crowning, and
spread the weld puddle.
ST-801 379-B
3/8, 7/16 in
3/8 in
1
2
3
4
5
6 7
Weld Bead Using The Tap Stabilizer
Connection With 17 Volts, 100 Amps
Weld Bead Using The End Stabilizer
Connection With 17 Volts, 100 Amps