Magnadyne M7a - Manual (Page 3)

3
Using The Transmitter To Arm The Security System
1. Press the button on the transmitter.
2. The horn and parking lights will chirp/flash once indicating that the system is now armed. The
vehicle’s door will lock upon arming when interfaced with the security system.
Silent Arming/Disarming:
1. Pressing the button on the transmitter will arm or disarm your security system, no
chirp sound will be heard, arm/disarm confirmation will be through the vehicles parking lights only.
Defective Sensor Reminder:
If the siren sounds off 3 chirps, you have left open a hood, door or trunk.
Shock Sensor Optional Sensor By-Pass:
Press the button once, the siren chirps once, the security system is now armed. Press the
button a second time within 5 seconds, the siren chirps twice, the shock sensor is now
bypassed. The sensor bypass feature is programmed to activate for one arming cycle only. The
security system will return to normal operation during the next arming cycle.
Active Lock & Arm
Active Arming/Disarming is Controlling your Security System via the remote Transmitter. This
Security System is Equipped with an Optional Passive Arming Feature, which Allows the Security
System to Arm 30 Seconds after the last Door is Closed.
1. Turn “OFF” ignition and exit the vehicle.
2. After al entrances are closed, the security system LED will flash fast for 30 seconds. If you
reopen any door, hood, or trunk. the security system LED will stop flashing. It will begin flashing
again once the vehicles entrances are closed.
3. After 30 second timer has elapsed, the security system will automatically “Arm”. The siren will
chirp once and the parking lights will flash once.
Passive Arming with Passive Door Locking:
The vehicles door will automatically lock after passive arming cycle has been completed.
Passive Arming Bypass:
While the LED is flashing for passive arming or automatic re-arm, press the button twice,
the security system will respond with 1 chirp and LED will turn “On”. The security system will
remain in this temporary state for as long as you wish. To exit passive bypass, press the “Lock”
or “Unlock” button and the system will return to normal status.
Note: While in passive arm Bypass Mode, you will be required to manually arm you system.
Following the “Active Arm” procedure above.
Passive Arming
Security System Operations
+
M7A-UM 6/14/06 14:44 Page 3