Magnadyne M7a - Manual (Page 8)

LED Display
LED Function
Off Disarmed
Slow Flash Armed
Fast Flash Passive Arming
On (Solid) Valet Mode
LED Function
2 flashes... pause Zone 2: Trigger on Trunk/Hood
3 flashes... pause Zone 3: Trigger on Door Switch
4 flashes... pause Zone 4: Trigger on Optional Sensor
5 flashes... pause Zone 5: Trigger on Ignition Switch
Chirp Indicators
Chirp Function
1 Chirp Arm
2 Chirps Disarmed
3 Chirps Defective Reminder
4 Chirps Disarm / Triggered
6 Chirps Car Locator
Parking Lights
Parking Lights Function
1 Flash Arm
2 Flashes Disarmed
3 Flashes Disarm / Triggered
12 Flashes Car Locator
Constant On Under Remote Control
Alarm Operating Condition
Siren, Horn Parking Light LED Doors Starter Dome Light
1. Arming 1 or 3 Chirps 1 Flash Slow Flash Locking Disable
2. Disarming 2 or 4 Chirps 2 or 3 Flashes Fast Flash Unlocking Turns on for 30 Seconds
3. Trigger Alarming Flashes Slow Flash Disable Flashes
4. Panic Alarming Flashes Flashes
5. Car Locator 6 Chirps 12 Flashes
8
Turbo Timer Mode (Also See Installation Manual)
Turbo Timer Mode keeps the engine running after arriving at you destination for a programmable
time period of 1, 3 or 5 minutes. This allows the system’s time to conveniently cool down the turbo
after you have left the vehicle.
To Activate:
1. While the engine is running, set the emergency brake and place the transmission to "Park".
2. Before turning off the engine, press and release and buttons at the same time. The light
will flash to indicate the remote start has entered Turbo Timer Mode.
3. Remove the “Ignition Key” from the key cylinder. The engine will keep running.
4. Exit and secure the vehicle. The Engine continues running until the pre-programmed time
elapsed.
M7A-UM 6/14/06 14:44 Page 8