Mitel 5610 - Manual (Page 5)

QUICK REFERENCE GUIDE
M Mitel (design) is a registered trademark of Mitel Networks Corporation. © 2009, Mitel Networks Corporation. All other products and services are the trademarks of their respective holders. All rights reserved.
Do Not Disturb
Do Not Disturb (DND) stops internal calls from ringing your handset. DND returns busy
tone to the caller. DND does not stop external calls from ringing your handset nor does it
affect your ability to make calls.
• To enable, dial the Do Not Disturb Feature Access code (default is *20), or to disable,
dial the Cancel No Not Disturb Feature Access Code (default is #20).
• Press or .
• Press .
Call Handoff
If your handset is twinned to your desktop phone via a personal ring group, you can use the
call handoff feature. This feature allows you to “push” an active call from your desktop
phone to your 5610 handset, or “pull” an active call from your 5610 handset to your desktop
phone. You active call handoff by pressing a Handoff feature key on your desktop phone. To
program a Handoff feature key, refer to your phone’s user guide for instructions.
To push a call to your 5610 handset
•
While on a call at your desktop phone, press the Handoff key. The call is transferred to
your 5610 handset.
• Press to continue the call on your handset.
To pull a call to your desktop phone
•
While on a call on your 5610 handset, press the Handoff key on your desktop phone.
• The call is presented on your desktop phone in handsfree mode. Lift the desktop phone
handset to continue the call using your desktop phone.
Remove Belt Clip Cover
Use the belt clip removal tool. Insert the tool between the belt clip cover and the phone.Then,
using your thumb, press down and slide the clip up and off the back of the phone.
Attach Belt Clip
Insert the clip belt into the back of the handset. Slide the clip down with your thumb to snap
the side tabs into place.