Magnadyne MV1020 - Manual (Page 17)

17
Power Harness Wiring:
The 4-wire harness provides battery and ignition
12 volts as well as a chassis ground. Route the
power harness to the point in the vehicle that
you will make the connections.
Red Wire: The red wire in the harness should
be connected to a +12 volt power wire that
is turned on and of by the position of the
ignition key.
Yellow Wire: The yellow wire in the harness
should be connected to a constant +12 volt
wire that is NOT turned on and off by the
position of the ignition key.
Black Wire: The black wire in the harness
should be connected to the chassis of the
vehicle using a ring terminal and self tap-
ping screw or bolt and nut.
Blue Wire: Connect to the common trigger
wire coming from all door pin switches (+).
Wiring Instructions
Specifications
Supply Voltage: 12V DC, Negative Ground
Current Consumption: 24 Watts Maximum
Fluorescent Dome Light: 3 Watts
Screen Format: 16:9
Resolution: 800 x 600 Pixels
A/V Input: 1
A/V Output: 1
IR Transmitter: Yes
FM Transmitter: Yes
Dimensions (mm): 310 (w) x 310 (d) x 48 (h)