Philips Magnavox 51MP6200D - Manual (Page 16)

8
Digital Channel selection delay
Due to the tuning complexity of subchannel digital
programming, the time to select and view a digital
channel may take slightly longer than what the viewer
is normally accustomed to (as compared to analog
channel programs).
Digital channel broadcasts contain program and
system data information that must be processed
before the channel selection can be displayed.
Channel tuning
Available channels:
- Cable (analog NTSC or digital QAM): max. from  to 35
- Antenna (analog NTSC or digital ATSC): max. from 2 to 69
If a tuned channel is not yet in the master channel map, the TV will attempt
to tune the channel and it will be added to the map.
If the channel is not acquired, a message will appear that the channel is not
available.
When you tune an audio-only digital subchannel, a display appears with the
message Audio only .
Subchannel selections
The new standards employed with digital broadcasting make it possible to receive
multiple program channels under a single major channel number which can be
selected by pressing the digit remote control direct-access channel number entry.
Tip :
After the installation of the TV channels has been done, always make a selection
in the Installation menu between Antenna or Cable whether you want to watch
Antenna TV channels or Cable TV channels.
If you make use of a signal splitter do not forget to put the switch in the
corresponding position.
Weak channel installation
This enables you to do a weak ATSC digital channel installation. This is only
available for TV channels installed via an antenna connection (see section on
Preparation, under Antenna).
& If a certain channel you expect to see is not tuned or is weak, you can install
it manually. Call your local broadcasting station to check what channel is
being transmitted to.
é Select that channel in the displayed list of TV channels (in the antenna mode).
“ The signal strength is displayed and updated continuously as you rotate the
antenna.
Software upgrade
This menu allows you to upgrade your TV software using a USB device.
USB upgrade
It is possible to initiate an upgrade procedure from a USB portable memory.
The memory device must be stored with the appropriate upgrade image
(and structure) which can be found on the www.magnavox.com/usasupport
website.
How to upload a new software version on your portable memory device, see
Annex , under Magnavox TV software upgrade with portable memory.
Channel search completed.
Finish
Digital channels found : 0
Analog channels found : 3
Television installation
Installation Weak channel installation
2
3
Settings
Software upgrade
4
5
Language
Autoprogram
Weak channel installation
6
7
8
9
4
This allows you to maximize the signal quality of weak channels by manually
rotating the antenna.
Installation 4 Software upgrade 2
Current software info
Local upgrades/app...
Settings
Weak channel installation
Language
Autoprogram
Software upgrade
This allows you to upgrade new TV software if available.