Makita RZ 100 - Manual (Page 12)

Refer to pages 28, 31, 32 before using template
Page 29
Additional T
emplates A
vailable on W
ebsite
Makita 3612 B
Router table fence reference line
Router mounting holes
Use this 6" scale to check accuracy when copied
Drill .500" hole through router table insert plate install #30 dust cover insert into .500" hole and press flush with top of insert plate
Router Raizer
Access Hole
Makita 3612 B
NOTE: This hole must be drilled 1/2" or .500" for #30 dust cover insert to fit properly
.
NOTE: This router requires a 3/4" pocket or use of 8" X 8" black rubber spacer for router table installation. Pages 4,5,6.
Note:
Cross lines for locating and drilling holes are accurate.
The illustration of subbase may vary
slightly in size and design, but is accurate enough for cutting the rubber spacer if required.
Router Raizer
Access Hole
3/4" reference circle for drilling the routers original subbase only
.
T
able
mounted, drill 1/2" hole in table top.
.500" reference circle for drilling table top or insert plate.
1/2" = .500
© 2000-2005 Router Technologies
All Rights Reserved