MartinLogan PASSAGE TM - Manual (Page 10)

10 Removing the End Caps for Painting
Required tools (not included):
Philips head scrwedriver
1 Prepare a flat surface with a cushion and/or blanket to
protect the Passage. Place the Passage driver side down.
WARNING! Be careful to put no weight on
the tweeter globe.
2 Using a Phillips head screwdriver remove 2 screws from
the back/bottom of the Passage (see figure 14).
3 Using a Phillips head screwdriver remove three screws
from the bottom edge of the Passage (see figure 15).
4 The end cap may now be safely removed (see figure 16).
Repeat steps 2–4 to remove other end cap.
Figure 14. Removing the end caps step 2.
R
EMOVING THE
E
ND
C
APS FOR
P
AINTING
Figure 15. Removing the end caps step 3.
Figure 16. Removing the end caps step 4.