Philips Magnavox mrd210 - Manual (Page 2)

Detailed playback features and additional functions are described in the
accompanying owner’s manual.
STANDBY ON VOLUME
OPEN•CLOSE
PREV NEXT SOURCE
PLAY•PAUSE STOP PROGRAM
DVD VIDEO DIGITAL SURROUND SYSTEM
AV IN
PROGRESSIVE SCAN
1
4
5
4 CHANNEL
3
2
3
Make sure your DVD system and
TV are connected and turned on!
Playing a disc
1
Press DISC on the remote control.
You can also press the SOURCE button on the front panel until “DISC” appears on the display panel.
2
Turn on the TV and select the correct Video In mode.
You should see the blue Philips DVD background screen on the TV (if no disc in the DVD system).
3
Press OPEN•CLOSE
0 on the front of the DVD system and load a disc, then
press the OPEN•CLOSE
0 again to close the disc tray.
Make sure the disc label is facing up. For double-sided discs, load the side you want to play face up.
4
Playback will start automatically. If not, press ÉÅ button.
If a disc menu appears, use
3 4 1 2 buttons on the remote to make the necessary selection, then press
OK to confirm. Or, use the numeric keypad on the remote to select features. Follow the instructions
given in the disc menu.
5
To stop playback, press STOP Ç.
Region Codes
DVDs must be labeled for ALL regions or Region 1, in order
to play on this DVD system.
ALL
1
1) Press SYSTEM MENU button.
The icon will be highlighted in the
menu bar on the TV screen.
2) Press 4 button to select the Picture Setup
Menu item
.
3) Press 2 button to enter the Menu.
4) Press 4 button to select ‘VIDEO OUT’
and 2 button to enter the Menu.
5) Press 34 to select and highlight :
S-VIDEO - if you use the S-Video connection.
PR PB Y/SCART - if you use the Component
Video Pr/Cr Pb/Cb Y
6) Press OK button to confirm.
DVD system Video Output Selection for
Proper Playback
S-VIDEO
PR PB Y / SCART
Note: SCART control not
available for use with your
DVD system.
got sound, no picture!!
Check the AV (Audio/Video) mode on
your TV.
* Usually this channel is between the lowest and
highest channels and may be called FRONT,
A/V IN, or VIDEO.
* Or, you may go to channel 1 on your TV, then
press the Channel down button repeatedly
until you see the Video In channel.
* Or, your TV remote control may have a button
or switch that chooses different video modes.
* Do not use channel 3 or 4 on the TV unless
you are using an RF modulator.
* See your TV manual for more details.