Moxa Technologies NPort 6110 - Manual (Page 17)

2-7
Housing
DIN-Rail
For many industrial applications, you will find it convenient to use the DIN-Rail
attachments, as shown below.
STEP 1: Use 2 screws per ear to attach DIN-Rail mounts to each of NPort
6110’s two ears.
⇒
STEP 2: Insert the top of the DIN-Rail
into the top slot of the
DIN-Rail mount.
STEP 3: Push the bottom of NPort
6110 so that the bottom of the
DIN-Rail snaps into DIN-Rail
mount’s bottom slot.
NOTE: The DIN-Rail mounting kit is an optional accessory.
To remove NPort 6110 from the DIN-Rail, simply reverse Steps 2 and 3 above.
Grasp the bottom of the NPort 6110 unit with both hands, and then use your
fingers to pull down slightly on the bottom slot of the DIN-Rail mounts to
release the bottom of the DIN-Rail from the DIN-Rail mount.