Miller Electric XMC 4000 - Manual (Page 10)

OM-221 694 Page 6
A Warning! Watch Out! There are possible
hazards as shown by the symbols.
1 Electric shock from wiring can kill.
2 Disconnect input plug or power before
working on machine.
3 Hazardous voltage remains on input
capacitors after power is turned off. Do
not touch fully charged capacitors.
4 Always wait 60 seconds after power is
turned off before working on unit, OR
5 Check input capacitor voltage, and be
sure it is near 0 before touching any
parts.
6 When power is applied failed parts can
explode or cause other parts to
explode.
7 Flying pieces of parts can cause injury.
Always wear a face shield when
servicing unit.
8 Always wear long sleeves and button
your collar when servicing unit.
9 After taking proper precautions as
shown, connect power to unit.
S-185 836
> 60 s
V
V
V
1 2 3 4 5
6 7 8 9
A
A Warning! Watch Out! There are
possible hazards as shown by the
symbols.
B Electric shock from wiring can
kill.
C Disconnect input plug or power
before working on machine.
D Read the Owner’s Manual
before working on this machine.
1
Consult rating label for input
power requirements, and
check power available at the
job site − they must match.
2 Read Owner’s Manual and
inside labels for connection
points and procedures.
3 Not Applicable
4 Having a loop of extra length,
connect grounding conductor
first.
5 Not Applicable
A B C D
Do not discard this product with
general waste.
Reuse or recycle Waste Electrical
and Electronic Equipment (WEEE)
by disposing at a designated collec-
tion facility.
Contact your local recycling office
or your local distributor for further
information.