Philips Magnavox 25i - Manual (Page 22)

22
B
LOCKING
P
ROGRAMMING
B
ASED ON
M
OVIE
R
ATINGS
1 2 3
4 5 6
7 8 9
0 A/CH
POWER
CC
STATUS
EXIT
SLEEP MUTE
MENU
CH+
CH–
VOL+
VOL–
Setup Code
Movie Rating PG
PG-13 R NC-17
Channel 9
Blocked By SmartLock
Movie Rating
Access Code
– – – –
Off On
Off On Off On Off On
X
Off On
SmartLock
Access Code XXXX
SmartLock
Access Code – – – –
Brightness
+ –
SmartLock
1
5
4
7
6
2
5
3
G
Off On
7
8
8
T here are two types of program rat-
ings within the SmartLock feature.
One is based on the Movie Industry rat-
ings while the other is based on the TV
Industry ratings. Both can be used to
block or censor programming that has
been rated in either manner.
Let’s first look at the Movie Rating
options of SmartLock:
Press the MENU button on the
remote to show the on-screen menu.
Press the CURSOR UP ▲ button
and the SmartLock control will appear
on the screen.
Press the CURSOR RIGHT ᮣ
button to display the SmartLock
Access Code control.
Enter the correct access code
number. “XXXX” shows on the
Access Code display as you press the
NUMBERED buttons. SmartLock
menu options will be displayed starting
with “Setup Code”.
Press the CURSOR UP ▲ or
DOWN ▼ buttons until the Movie
Rating control appears on the screen.
Press the CURSOR RIGHT ᮣ
button to display the first of the
Movie Rating options (G).
Press the CURSOR UP ▲ or
DOWN ▼ button to display any of
the Movie Rating (G, PG, PG-13, R,
NC-17, or X) options.
When displayed, Press the CUR-
SOR RIGHT ᮣ button to turn the
option OFF (which will allow viewing),
or press the LEFT
ᮤ button to turn the
option ON (which will allow blocking).
When a rating is set to block,
all higher ratings will be auto-
matically blocked as well. Example: If
the the PG-13 rating is set to block, the
R, NC-17, and X ratings will also be
blocked.
S MART H ELP
Each Movie
Rating can be
turned “ON”
or “OFF.”
To view a program blocked by
the Movie Rating options, enter
your 4 digit access code. This
will disable all blocked Movie
Ratings until the TV is powered
off and on again. Then the block-
ing options will be restored.
NOTE: Remember, if
you ever forget your
Access Code, the 0,7,1,1
access code is the default
code or a way to reset
the code when the cur-
rent access code is not
known.