MITSUBISHI ELECTRIC 737 - Manual (Page 45)

45
5
NetCommand IR Control
NetCommand IR home-theater control is avail- •
able on 837 series models.
IR emitter cables are available for purchase
•
from Mitsubishi. Visit www.mitsuparts.com or call
800-553-7278 and request one of the following:
242D483020 - (two-ended cable)
299P254020 - (four-ended cable).
NetCommand setup is optional. •
You can perform NetCommand setup when the TV •
first recognizes a device during Auto Input Sensing
or at any convenient time afterward.
Important Note on NetCommand
Be sure to connect the IR emitter cable to the
TV and properly place the emitters so that
NetCommand can control your devices.
NetCommand operates by sending remote control •
signals from the TV to your other devices via the
IR (infrared) emitters, telling the devices to play,
record, change inputs, adjust volume, change chan-
nels, or perform other functions. All this is accom-
plished with the TV’s remote control left in
TV mode.
You may wish to use NetCommand IR control to •
supplement control of CEC-enabled devices.
About NetCommand IR Control