Miele W3033 - Manual (Page 33)

Cleaning the water inlet filters
The washer has two water inlet filters to
protect each inlet valve. These filters
should be checked and cleaned if
necessary every 6 months. This may
need to be done more frequently with
some water supplies.
^ Turn off the water supply.
^ Unscrew the inlet hose from the valve
by turning the connector counter-
clockwise using a wrench if
necessary.
^ Remove the rubber seal, 1 , from the
connector.
^ Using needle nose pliers, grasp the
plastic filter, 2 , and pull it out of the
hose connector.
^ Clean the filter under running water
and carefully remove any large
particles.
^ Replace the filter and seal then
reconnect the hose.
^ Slowly turn on the valve and check
for leaks. If water leaks, tighten the
bolt.
Both filters must be put back in
place after cleaning.
Cleaning and care
29