Miele CVA4075 - Manual (Page 49)

Preparing / dispensing problems
No water, steam or milk is dispensed from the froth dispenser.
– The water tank is not correctly
inserted.
– The dispenser is clogged.
– Take out the water tank and reinsert it.
– Clean the froth dispenser as described
in "Cleaning and Care - Froth
dispenser/Intake hose".
The grinding sounds louder than usual.
There could be pebbles within the
coffee beans. Turn off the unit immediately.
Contact the Miele's Tech. Service.
The grinding is quieter than usual.
The coffee bean container is empty.
The respective message appears in
the display. Wait until no sound is heard and refill the
coffee bean container.
The coffee/espresso flows too fast into the cup.
The grind control is set too coarse. Set the grind control to a finer grind.
The coffee/espresso flows too slow into the cup.
The grind control is set too fine. Set the grind control to a coarser grind.
The coffee/espresso is not hot enough.
– Were the supply lines pre-heated?
– The temperature is set too low.
– Check if the brew unit is clogged.
– The smaller the cup, the more
important it is to pre-heat.
– Check on what temperature range the
coffee type is set.
– Clean the brew unit.
No drink is prepared although the beans were grinded and enough water is
in the container.
– The grind control is set to the
finest or the grind amount is set to
the maximum.
– The process is timed, the process
might need so long, there is no
time for brewing any more.
– Set the grind control or the grind
amount to a different position.
Frequently asked questions
49