Miele 05 620 661 - Manual (Page 21)

7. Adjust and secure the front
panel
Once installed, the panel can be raised
or lowered up to
1
/
16
" (2 mm) to match
the cabinet lines.
Adjust one side of the door panel at a
time using a T20 Torx screwdriver.
Do not use a power screwdriver to
adjust or secure the decorative
panel to the dishwasher.
^ If the upper screws on the edge of
the door are not loose, loosen them
slightly.
^ The panel can be raised or lowered
by turning the lower screw on each
side of the dishwasher door.
To raise the panel turn clockwise.
To lower the panel turn counterclock-
wise.
^ Once this side of the panel lines up
with the cabinets, secure it by tight-
ening the upper screw on the edge of
the dishwasher door.
^ Repeat the process with the other
side of the panel.
^ Close the door.
^ Check the alignment. Readjust if
needed.
^ Insert the supplied end caps into the
four screw holes.
Installation
21