Mio MioMap v3.3 C320 - Manual (Page 73)

6.1.2 Automatic Night Colors
Using the automatic night mode, MioMap will change between the daylight and night
color schemes a few minutes before sunrise and a few minutes after sunset based
on the time and location information provided by your GPS. Once you set a
permanent color scheme in the Quick menu (Page 43), this automatic mode turns
off. If you need MioMap to switch between colors for you again, you need to re-
enable this feature.
6.1.3 Warn When Speeding
Maps may contain information about the speed limits of the road segments. MioMap
is able to warn you if you exceed the current limit. This information may not be
available for your region (ask your local dealer) or may not be fully correct for all
roads in the map. This setting lets you decide whether you want to receive the
warnings or not.
6.1.4 Speed Warning Options
When speed warning is turned on, the values of these controls determine when the
warning will be triggered.
You can set two different kinds of behavior for the warning: one is applied up to a
certain speed limit and the other one is used above that.
6.1.4.1 Speeding tolerance
MioMap will warn you when you exceed the speed limit by the amount specified
here. Select whether you want to specify the tolerance as a Fixed value (offset to the
speed limit) or as a Percentage.
The slider will change depending on which mode you have chosen.
Both positive and negative values can be given in either offset or percentage mode.
6.1.4.2 Alternative speed limit
If the speed limit of the current road segment equals or is above this limit, the speed
warning will use the alternative tolerance instead of the previous one.
Move the slider to its rightmost position to turn off the alternative speed warning.
Then the settings of the upper slider will determine the warning for all roads.
73